The soda can sealing unit is suitable for filling and sealing soda cans in the beer and beverage industry. It is an independently developed soda can filling and sealing unit based on the digestion and absorption of advanced beer soda can filling and sealing machines at home and abroad. Filling and sealing are designed as a whole, and the filling system of the can sealing machine is powered by the sealing system to ensure absolute synchronization and coordination between the two. Adopting the most advanced mechanical, electrical, and pneumatic control technologies, and utilizing the principle of equal pressure filling, the filling speed is fast, and the liquid level is stable after filling with minimal material loss. The sealing quality is good, the whole machine runs smoothly, the appearance is beautiful and elegant, the operation and maintenance are convenient, and the production speed is variable frequency and speed regulation.
Daily maintenance precautions for the can sealing machine:
Firstly, adjust the distance between the can holder and the pressure head of the can sealing machine: loosen the spare cap on the guide shaft (screw) at the lower end of the can holder, rotate the can holder with the pressure head in contact with the lid as the base point, and then rotate the can holder upward by 2-3mm to tighten the spare cap.
Secondly, adjust the distance between the pressure head and the sealing wheel: Firstly, adjust the left and right distance between the pressure head and the first sealing wheel, based on a distance of 0.5mm between the sealing wheel and the pressure head. The pressure head and the sealing wheel should not rub against each other, and the smaller the distance, the better; Adjust the up and down distance between the pressure head and the first sealing wheel, with the minimum gap between the lower end of the sealing wheel and the upper end of the pressure head not in contact. Next, adjust the distance between the pressure head and the second sealing wheel using the same method.
Thirdly, the gap between the pressure head and sealing wheel of the can sealing machine can be adjusted according to the hardness of the lid. The iron cover can be adjusted closer. The aluminum cover can be adjusted further. After adjustment, tighten the fixing screws and try sealing 2-3 pieces. After checking that they meet the standards, they can work continuously.
Fourthly, every time the can type is changed, the pressure head and can tray should be replaced according to the size of the lid.
Fifth, mechanical maintenance: The motor must not be missing phase, the gear transmission part should be lubricated with lithium based lubricating oil once a month, and the motor spindle should be running without lifting or lowering the tank tray. Adjust or replace the V-belt.
Cn
English
